发动机散热器的软管长期使用会老化，容易破碎，如果散热器入口，软管在驾驶过程中破裂，高温水的飞溅，将形成从发动机盖的水蒸气的质量，这种现象发生，并立即选择一个安全的地方停车场，并采取紧急措施，以解决。下面小编就简单的为您讲解一下解决发动机散热器进水破裂的措施：

　　Engine radiator hose long-term use will be aging, easy to break, if the radiator inlet, hose in the process of driving broke, the high temperature water splashing, will form the mass of steam from the bonnet, this phenomenon occurs, and immediately choose a safe place to park, and take emergency measures to solve. Below small make up for you to explain the solution to the engine radiator water fracture measures:

　　一般情况下，散热器进、软管接头处更容易出现裂缝和渗漏，则可以用剪刀把损坏的部位剪下来，并将软管重新插入散热器入口接头，并用卡子或线夹紧。如果在中间裂开的软管可以用胶带扎漏裂缝，先用干净的软管包绕前软管，在干燥后的部位，织物包裹着软管的泄漏，因为当发动机是在软管高压下操作时，要尽量用胶带包裹紧。如果手头没有胶布，还可以先将塑料纸缠在裂口上，然后将旧布剪成条状缠在软管上。有时软管裂口较大，缠扎后仍可能漏水，这时可将水箱盖打开，以降低水道内的压力，减少泄漏。

　　In general, the radiator into, hose joints are the most prone to cracks and leakage, you can use scissors to cut out the damaged parts, and the hose re-inserted into the radiator inlet joint, with clip or line clamp. If the hose that breaks in the middle can be taped, wrap a clean hose around the front hose first. In the dry area, the fabric wraps the hose leak, because when the engine is operating under hose pressure, try to wrap the hose as tightly as possible. If you don't have the tape on hand, you can also wrap the plastic paper around the tear and then cut the old cloth into strips and wrap them around the hose. Sometimes the hose tear is larger, after tying may still leak, then you can open the tank cover, in order to reduce the pressure in the channel, reduce the leakage.

　　采取以上措施后，济南自动变速箱维修小编提醒您发动机转速不能太快，要尽量挂高档行驶，行驶中还要注意水温表的指针位置，发现水温过高时要停车降温或补充冷却水。

　　After taking the above measures, small make up remind you that the engine speed can not be too fast, to try to hang high-grade driving, driving also pay attention to the pointer position of the water temperature meter, found that the water temperature is too high to stop to cool or add cooling water.