We know that the gearbox is one of the important devices on the car, so it is very important to maintain and select the gearbox. Many automobile maintenance companies in Jinan have set up some Jinan automatic transmission maintenance, Jinan gearbox maintenance professional repair shop. Since the gearbox is so important to the car, today we would like to work with you about the disassembly and assembly precautions of automatic transmission maintenance.

在此小编要提醒大家提醒大家，对于变速箱的维修一定要找具有维修经验的公司维修!对于自动变速箱维修时的拆装注意事项，主要有以下五点：

In this section, I would like to remind you that for the maintenance of the gearbox, you must find a company with professional maintenance experience to repair! For the disassembly and assembly precautions of automatic transmission maintenance, there are mainly the following five points:

1、先卸下万向节螺钉，使变速器和传动轴的万向节分离;再卸下离合器罩螺钉，使变速器和离合器分离;如果是远程操纵的变速器，则将操纵机构与变速器本体分离将变速器从汽车上拆卸下来。

1. First remove the universal joint screw to separate the universal joint of the transmission and transmission shaft; then remove the clutch cover screw to separate the transmission and clutch; if it is a remote control transmission, separate the control mechanism from the transmission body, and finally remove the transmission from the vehicle.

2、清洗变速器外部的油泥和污物，注意保护前后的轴头。

2. Clean the oil sludge and dirt outside the transmission, and pay attention to protect the front and rear axle heads.

3、拧下放油螺塞，放净变速器中的润滑油，再琶油螺塞。

3. Screw the drain plug, drain the lubricating oil in the transmission, and then plug the oil plug.

4、找一个干净无灰尘的场地，利用拆卸工具和铜棒，开始拆卸变速器。拆卸顺序一般是：变速器盖、轴、第二轴、中间轴、倒挡轴。5、拆卸零件时，先看好零件原始的方向和位置后再拆卸，必要时，做好记录;拆下的零件按拆卸先后顺序，分部位排放整齐，必要时可用线或铁丝将各零件按顺序串在一起;齿轮可按原方向和位置套在轴上，以防装错或漏装。

4. Find a clean and dust-free place and use the removal tool and copper bar to start disassembling the transmission. Generally, the disassembly sequence is: transmission cover, first shaft, second shaft, intermediate shaft and reverse gear shaft. 5. When disassembling parts, take good care of the original direction and position of the parts before disassembly. If necessary, make records. The removed parts shall be arranged in order according to the disassembly sequence. If necessary, wire or iron wire can be used to string the parts together in order; the gear can be set on the shaft according to the original direction and position to prevent wrong or missing assembly.

以上就是今天小编要和大家分享的相关知识，希望对大家有所帮助。

The above is today's small editor to share with you the relevant knowledge, I hope to help you.