1、用专门的清洗剂彻底清洗合力变速箱冷却器和冷却油管，确保无任何杂物，油道畅通无阻，安装完毕后，检查流量压力，正常情况下变速箱的压力至少要达到12KG以上。必要时更换水箱冷却器油管；
1. Thoroughly clean the Heli transmission cooler and cooling oil pipe with special cleaning agent to ensure that there are no sundries and the oil passage is unblocked. After installation, check the flow pressure. Under normal conditions, the transmission pressure should be at least 12KG. Replace the water tank cooler oil pipe if necessary;
2. Shandong transmission maintenance personnel remind you to check whether the torque converter is installed in place;
3、检查发动机和合力变速箱之间定位销和各个螺丝是否安装齐全；
3. Check whether the locating pins and screws between the engine and the resultant gearbox are completely installed;
4、检查变扭器螺丝是否过长和安装螺栓扭紧后机器是否紧密贴合；
4. Check whether the torque converter screws are too long and whether the machine fits tightly after the installation bolts are tightened;
5、检查飞轮跳动量（参考值：在1.0mm以下）；
5. Check the flywheel runout (reference value: below 1.0mm);
6、检查挂档杆和油门拉线和真空管路是否调节好；
6. Check whether the shift lever, accelerator cable and vacuum pipeline are properly adjusted;
7、加注原厂规定的自动变速箱油（手动档车型要另外加齿轮油），检查油面高度，不可过多或过少；
7. Fill in the automatic transmission oil specified by the manufacturer (gear oil shall be added additionally for the model with manual gear), and check the oil level, which shall not be too much or too little;
8、检查机脚胶是否损坏；
8. Check whether the foot glue is damaged;
9、确定各线插、搭铁线完全装好，传动轴、半轴按规定装配；
9. Make sure that all wire plugs and grounding wires are completely installed, and the transmission shaft and half shaft are assembled as required;
10、变速箱是车体中非常重要的系统，直接影响到行车的安全，建议一旦发现问题后应及时进行维修。
10. The gearbox is a very important system in the vehicle body, which directly affects the safety of driving. It is recommended to repair it in time once any problem is found.
What inspection is required after the transmission is repaired? The above is the relevant answer to the question. I hope it can help you. Please come to our website for more matters http://www.jnbsx.com consulting service
