随着消费者对汽车的了解，变速箱作为动力系统的一部分，在消费者购买汽车时自然成为一个重要的考虑因素。变速箱维修每个档位都有不同传动比，相当于小齿轮与大齿轮的啮合能产生不同的转速，低速行驶时用低传动比（3档及以下），大轴转速低于发动机转速，可获得更大的驱动力，高速时用高传动比（4档及以上），大轴转速高于发动机转速，降低牵引力获得更高速度，切档位即选择不同尺寸的齿轮和大轴的齿轮啮合。
With the consumers' understanding of the car, gearbox, as a part of the power system, naturally becomes an important consideration when consumers buy a car. Gearbox maintenance has different transmission ratios for each gear position, which is equivalent to the simultaneous interpreting of the meshing between the pinion and the big gear. The low transmission ratio (3 gears and below) can be obtained at low speed, and the greater shaft speed is lower than the engine speed. The greater driving force can be obtained. When the speed is high, the high transmission ratio (4 gears and above), the shaft speed is higher than the engine speed, and the traction force can be reduced more quickly. Gear shifting means that gears of different sizes are selected to mesh with gears of main shaft.
变速箱维修起步、怠速停车、低速或高速行驶、加速、减速、爬坡和倒车等，这就要求汽车的驱动力和车速能在相当大的范围内变化，而目前广泛采用的活塞式发动机的输出转矩和转速变化范围较小。为了适应经常变化的行驶条件，同时使发动机在有利的工况下(功率较高、油耗较低)工作，在传动系统中设置了变速器。
Transmission maintenance start, idle parking, low or high speed driving, acceleration, deceleration, climbing and reversing, etc., which requires the driving force and speed of the car to change in a considerable range, while the widely used piston engine has a smaller range of output torque and speed. In order to adapt to the frequently changing driving conditions and make the engine work under favorable working conditions (high power and low fuel consumption), a transmission is set up in the transmission system.
众所周知，自动变速器分为自动变速器和手动变速器，自动变速器以其操作方便、操作方便等优点在市场上占有很高的市场份额。然而，自动变速器的维护难度大，维护成本高。
As we all know, automatic transmission is divided into automatic transmission and manual transmission. Automatic transmission occupies a high market share in the market with its advantages of convenient operation and easy operation. However, the maintenance of automatic transmission is difficult and costly.
自动变速箱配有大量电磁阀，以及非常复杂的机械部件。在维修过程中，维护过程中存在轻微疏忽，这可能导致自动变速器报废。因此，应去的地方自动修理变速箱。包头自动变速箱养护只想说，如果自动变速器损坏，它的性能如何？
The automatic transmission is equipped with a large number of solenoid valves and very complex mechanical components. In the process of maintenance, slight negligence in the maintenance process may cause the automatic transmission to be scrapped. Therefore, should go to professional place automatic repair gearbox. Baotou automatic transmission maintenance just want to say, if the automatic transmission damage, its performance?
1。驾驶时的震惊感。
1。 Driving shock.
2.进入/转移影响，甚至停滞。
2. Impact of entry / transfer, even stagnation.
自动变速箱维修
Automatic transmission maintenance
3.车辆打滑，无法运行。开始无法启动。
3. The vehicle skids and cannot run. Start failed to start.
4.有异常的噪音（1.驾驶时噪音异常，踩油门的声音变大;2.驾驶内部发出沙沙声，踩油门后没有声音，有声音转移等）。
4. There is abnormal noise (1. The noise is abnormal when driving, and the sound of stepping on the accelerator becomes louder; 2. There is a rustling sound inside the driver, there is no sound after stepping on the accelerator, there is a sound transfer, etc.).
自动变速器是整个汽车的核心部件，因此很有必要做好它的维修工作。自动变速器维修人员说，许多车主在正常驾驶过程中容易犯一些低级错误，随着时间的推移，这会对变速箱造成致命的损坏。因此，只要做好汽车自动变速器的保养工作，就可以延长汽车的使用寿命，使行驶里程达到理想状态！
Automatic transmission is the core part of the whole car, so it is necessary to do its maintenance work well. Automatic transmission maintenance personnel said that many car owners are prone to make some low-level mistakes in the normal driving process, which will cause fatal damage to the transmission over time. Therefore, as long as we do a good job in the maintenance of the automatic transmission, we can extend the service life of the car and make the driving mileage reach the ideal state!
